Swing Bike Update 4/13

I’ve been able to get some cutting done this week, some in the machine shop, some at home with my borrowed hacksaw and angle grinder. I just have 3 more cuts before I’m able to start prepping the tubes for welding, which should get done after my System Dynamics test tomorrow. I also sourced some spray paint from McGuckins, so that’s coming along as well. Everything is on schedule to be completed on time. Below are pictures of some of the cut tubes.

IMG_20160413_205614IMG_20160413_205629IMG_20160413_205650

Previous Post
Update April 13th-Fiber Optic Jellyfish
Next Post
Update: 4/13/2016 Lazy Susan Kitchen Device (LSKD)

2 Comments. Leave new

  • You gonna miter the tubes at all?

    Reply
  • Meridith Richter
    April 15, 2016 3:41 pm

    Looks like it is coming along! What colors of spray paint did you get? Did you decide on a certain pattern or application method? Are you going to completely cover up the original logos/metal with paint? It might be kind of interesting to keep a little of the original incorporated in with the new design. Good luck with the welding!

    Reply

Leave a Reply to Albert Como Cancel reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.