Shut-Box Constraints

Constraint 1: The wood I intend on using to create the box is plywood and with the fragility of the wood I am worried it will split when I drill into it.

Constraint 2: The tabs with the numbers on them I planned on using 0.5in thick wood, but the laser cutter only goes up to a thickness of 0.25in.

Constraint 3: Aesthetically I am concerned about burning the wood too much, but at the same time I may go with a rustic sort of aesthetic so the burn marks from the laser cutter may actually fit with the vibe.

Constraint 4: Time is a constraint and that’s why I am trying to utilize the laser cutter because machining will take a considerable amount of time, but with the size of the wood I may need to or I will have to redesign.

Constraint 5: Cost is my last constraint and I really would like to keep the cost under $30, I found that at McGuckin’s Hardware that this may not be feasible and need to look into cheaper options.

Previous Post
Top 5 Constraints
Next Post
Top 5 Constraints: Smart mirror

2 Comments. Leave new

Leave a Reply to Jean Hertzberg Cancel reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.