Progress Report March 17

9 years ago

2016, Student Work

I am still in the part acquisition phase and planning for manufacturing phase of my project. So far I have acquired the tubeset that I will use, and the fitting lugs, I still need drop-outs, braze paste, and paint but those should arrive soon. I plan to begin cutting the tubeset.

3 Comments. Leave new

Albert Como
March 27, 2016 9:39 pm

I’ve just been using pre-fluxed braze rods. 1/16″ RBZnCU-C rods to start the braze, generic brass for filling out the fillets. You oxy torching?

Log in to Reply
Matthew Sturm
March 27, 2016 2:51 pm

What is going to be the hardest part of your manufacturing phase when you are ready for that? Will you need to spend more time on the tube-cutting or on the brazing?

Log in to Reply
Anfal Abdulrahman
March 20, 2016 1:35 pm

you seem well acquainted with what you need. good luck!

Log in to Reply

You must be logged in to post a comment.

Infinity mirror project progress

Progress Update