I am still in the part acquisition phase and planning for manufacturing phase of my project. So far I have acquired the tubeset that I will use, and the fitting lugs, I still need drop-outs, braze paste, and paint but those should arrive soon. I plan to begin cutting the tubeset.
Search for content or authors
This Year’s Students
- Abigail Angwin
- Adlai White
- Alexis Cisneros
- Alex Fitzgerald
- Alex Gebben
- Alex Reynolds
- Aj Terio
- Andres Serrano
- Aryan
- Ari Matrajt Frid
- Arjun Mody
- Barrett Lister
- Ben Clairday
- Benjamin Hyde
- Blake Wilson
- Lavender Giebner
- Brandon Phillips
- Cannon Leitz
- Chris Wachuta
- Colton Huff
- Collin Kendall
- Cole Metcalf
- Collin Ruprecht
- David Li
- Duncan Laird
- Dylan Breglio
- Efrosini Krokos
- Emilee Novak
- Ethan Polacsek
- Ethan Sanchez
- Ethan Silverman
- Fin McKemey
- Garrett Miller
- Grreshan Ramesh
- Hailey Usher
- Helen Do
- Ian Farrar
- Ian O'neill
- Jason Allshouse
- Jace Aschbrenner
- Jarod Ocampo
- Jadin Zaccagnino
- Jess Corbitt
- Josh Beijer
- John Bileschi
- Jon Ezell
- Jonathon Gruener
- Josh Gregory
- Josh Sweeney
- Juliette Goubeaud
- Katie Schutt
- Kevin Kim
- Kelso Norden
- Kyra Anderson
- Kyle Hashiro
- Kyle Pohle
- Luke Nicol
- Luke Prins
- Max Lantz
- Maddox Mitchell
- Matthew Osborn
- Max Palish
- Michael Becerra
- Michael Gray
- Nicholas Gotlib
- Nick Olguin
- Noah Howell
- Oliver White
- Peter Arnold
- Riley Menke
- Sam Biehle
- Sammie Duran
- Sam Gluskoter
- Sarah Pepper
- Sean Riddle
- Sierra Greeley
- Sophie Berry
- Sophia Montie
- Tim Hellweg
- Tiana Vitry
- Trent Bjorkman
- Travis Mulford
- Venkata Sanyasi Krishna Vidhan Rallapalli
- Vincent Tang
- Yuting Wang
- Aryan Gandhi
- Jean Hertzberg
- Shrey Naresh Solanki
This work is licensed under CC BY-NC-SA 4.0
3 Comments. Leave new
I’ve just been using pre-fluxed braze rods. 1/16″ RBZnCU-C rods to start the braze, generic brass for filling out the fillets. You oxy torching?
What is going to be the hardest part of your manufacturing phase when you are ready for that? Will you need to spend more time on the tube-cutting or on the brazing?
you seem well acquainted with what you need. good luck!