As of today, I have acquired all the materials needed for my project. This includes the wood siding, 2×4’s, drawer slides, and screws. All that I need to do now is to cut and assemble the wood. I have all the laser cut designs finished on Rhino3D and I’ve scheduled a time to cut for next week. Once this is done, all that will be left will be driving some screws and sanding some edges.

Previous Post
Final Stretch: Candle Holder
Next Post
Final Stretch: Bamboo Fly Rod

4 Comments. Leave new

  • Tori Herfert
    Tori Herfert
    April 18, 2017 2:27 pm

    I remember at the prototype you had some seriously cool laser cuts on your prototype. I am excited to see which cuts you decided to go with and which wood you are using. I think you will have plenty of time to finish and it is going to turn out great. Can’t wait to see.

    Reply
  • Jake Silverman
    Jake Silverman
    April 17, 2017 12:26 pm

    You seemed to have planned well and are on track to finish. I am looking forward to see what kind of design routes you took eith the laser cutting design

    Reply
  • Ridhvik Gopal
    Ridhvik Gopal
    April 17, 2017 12:16 pm

    You have to planned out well! And have enough buffer time remaining to take care of any kinks. Kudos and all the best!

    Reply
  • Levi Cortright
    Levi Cortright
    April 16, 2017 11:52 pm

    I am excited to see how this turns out. Good job at keeping to a reasonable schedule. I will have some hurdles this week. Cannot wait to see it at expo!

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.

Menu